Self-Diag Result Mode
- Drive at 30 km/h or more for approximately 1 minute before performing the self-diagnosis.
Display Item List
SELF-DIAG RESULT MODE CHART
| DTC | Items (CONSULT-III screen terms) | Diagnostic item is detected when... | Possible cause |
|---|---|---|---|
| C1201 | CONTROLLER FAILURE [C1201] | Malfunction has occurred inside AWD control unit. | Internal malfunction of AWD control unit |
| C1203 | ABS SYSTEM [C1203] | Malfunction related to wheel sensor has been detected by ABS actuator and electric unit (control unit). | ABS malfunction
|
| C1204 | 4WD SOLENOID [C1204] | Malfunction related to AWD solenoid has been detected. | Internal malfunction of electronic controlled coupling |
| C1205 | 4WD ACTUATOR RLY [C1205] | Malfunction has been detected from AWD actuator relay integrated with AWD control unit, or malfunction related to AWD solenoid has been detected. | Internal malfunction of AWD control unit |
| C1210 | ENGINE SIGNAL 1 [C1210] | Malfunction has been detected from ECM. | Malfunction of engine control system
|
| U1000 | CAN COMM CIRCUIT [U1000] | When AWD control unit is not transmitting or receiving CAN communication signal for 2 seconds or more. | CAN communication line error |
| U1010 | CONTROL UNIT (CAN) [U1010] | When detecting error during the initial diagnosis of CAN controller of AWD control unit. | AWD control unit error |
| NO DTC IS DETECTED. | NO DTC IS DETECTED. FURTHER TESTING MAY BE REQUIRED. | No NG item has been detected. | - |
CAUTION:
- If "CAN COMM CIRCUIT [U1000]" or "CONTROL UNIT (CAN) [U1010]" is displayed with other DTCs, first perform the trouble diagnosis for CAN communication line.
- Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch OFF if AWD warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.
How to Erase Self-Diagnostic Results
- Before erasing DTC memory, start the engine and drive at 30 km/h or more for approximately 1 minute. Check that ABS warning lamp turns OFF.NOTE: Make sure that ABS warning lamp turns OFF by driving for a minute at vehicle speed of 30 km/h (19 MPH) or more after turning ignition switch OFF if AWD warning lamp turns ON with system malfunction of "ABS SYSTEM [C1203]". AWD warning lamp may not turn OFF if it is normal unless ignition switch turns OFF at once and engine restarts after that.