Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
4. Turn ignition switch ON.
5. Set selector lever to D (A/T) or 1st (M/T) position.
6. Check the voltage between ECM harness connector and ground.
   TERMINALS VOLTAGE REFERENCE
   
   

   ECM		Ground	Condition		Voltage
   Connector	Terminal
   F101	30 [TP sensor 1 (bank 1)] 31 [TP sensor 1 (bank 2)]	Ground	Accelerator pedal	Fully released	More than 0.36V
   				Fully depressed	Less than 4.75V
   	34 [TP sensor 2 (bank 1)] 35 [TP sensor 2 (bank 2)]			Fully released	Less than 4.75V
   				Fully depressed	More than 0.36V

Is the inspection result normal? 

YES: INSPECTION END

NO: GO TO 2.

1. Replace malfunctioning electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".

   INSPECTION END