Component Inspection

1. Turn ignition switch OFF.
2. Disconnect combination switch (spiral cable) harness connector M303.
3. Check resistance between combination switch harness connector terminals under the following conditions.
   TERMINALS RESISTANCE REFERENCE
   
   

   Combination switch		Condition	Resistance
   Connector	Terminals
   M303	13 and 16	MAIN switch: Pressed	Approx. 0 Ω
   		CANCEL switch: Pressed	Approx. 310 Ω
   		DISTANCE switch: Pressed	Approx. 740 Ω
   		SET/COAST switch: Pressed	Approx. 1, 400 Ω
   		RESUME/ACCELERATE switch: Pressed	Approx. 2, 600 Ω
   		All ICC steering switches: Released	Approx. 5, 500 Ω

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace ICC steering switch