Basic Inspection

WARNING: This page is about a different car, the 2008 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

INSPECTION START
Turn ignition switch "OFF".

NOTE: Before starting operation check, open front windows.

GO TO 2.
CHECK SECURITY INDICATOR LAMP
1. Lock doors using keyfob or ignition key.
2. Check that security indicator lamp illuminates for 30 seconds.
Security indicator lamp should illuminate.

OK: GO TO 3.

NG: Perform diagnosis and repair. Refer to , "COMPONENT FUNCTION CHECK ".
CHECK ALARM FUNCTION
1. After 30 seconds, security indicator lamp will start to blink.
2. Open any door before unlocking with keyfob or ignition key.
Does the alarm function properly?

Yes: GO TO 4.

No: Check the following.
- The vehicle security system does not phase in alarm mode. Refer to , "SYMPTOM TABLE ".
- Alarm (horn and headlamp do not operate. Refer to , "SYMPTOM TABLE ".
CHECK ALARM CANCEL OPERATION
Unlock any door or open back door using keyfob or ignition key.

Alarm (horn, headlamp and hazard lamp) should stop.

OK: INSPECTION END.

NG: Check door lock function. Refer to "DOOR LOCK AND UNLOCK SWITCH : SYSTEM DESCRIPTION ".