CONSULT-III Function (RAS/HICAS): Function
CONSULT-III can display each self-diagnostic item using the diagnostic test modes shown following.
CONSULT-III FUNCTION REFERENCE CHART
| Diagnostic test mode | Function |
|---|---|
| SELF-DIAG RESULTS | Receives self-diagnosis results from RAS control unit and indicates DTCs. |
| DATA MONITOR | Receives input/output signals from RAS control unit and indicates and stores them to facilitate locating cause of malfunctions. |
| CAN DIAG SUPPORT MNTR | Monitors transmitting/receiving status of CAN communication. |
| ACTIVE TEST | Sends command to RAS actuator to change output signals and check operation of output system. |
| ECU PART NUMBER | Displays RAS control unit part number. |