Check Tilt Sensor Circuit

With CONSULT-III 

With "TILT SEN" on the DATA MONITOR, operate the tilt switch to make sure voltage changes.

Without CONSULT-III 

1. Turn ignition switch OFF.
2. Check voltage between automatic drive positioner control unit connector and ground.
   VOLTAGE SPECIFICATION
   
   

   Automatic drive positioner control unit connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M6	7	Ground	Tilt top position	1
   			Tilt bottom position	3.8

OK or NG 

OK: Tilt sensor circuit is OK.

NG: GO TO 2.

Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect automatic drive positioner control unit connector and tilt sensor connector.
2. Check continuity harness between automatic drive positioner control unit connector and tilt sensor connector.
   CONTINUITY SPECIFICATION
   
   

   A		B		Continuity
   Automatic drive positioner control unit connector	Terminal	Tilt sensor connector	Terminal
   M6	7	M37	2	Yes
   M7	33		3
   	41		1

3. Automatic drive positioner control unit connector and ground.
   CONTINUITY SPECIFICATION
   
   

   A		Ground	Continuity
   Automatic drive positioner control unit connector	Terminal
   M6	7		No
   M7	33
   	41

OK or NG 

OK: GO TO 3.

NG: Repair or replace harness.

Fig 2: Checking Continuity Harness Between Automatic Drive Positioner Control Unit Connector And Tilt Sensor Connector

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Connect automatic drive positioner control unit connector.
2. Check voltage between automatic drive position control unit connector and ground.
   VOLTAGE SPECIFICATION
   
   

   Terminals			Voltage (V) (Approx.)
   (+)		(-)
   Automatic drive positioner control unit connector	Terminal
   M6	7	Ground	5

OK or NG 

OK: Replace telescopic sensor.

NG: Replace automatic drive positioner control unit.

Fig 3: Checking Voltage Between Automatic Drive Position Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.