Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IMAGE QUALITY SETTING
1. Enter the display adjustment screen by pressing the "DISP" switch.
2. Turn the light control switch to the TA4L position.
3. Check if "Day Mode" on the display is ON.
  OK: "Day Mode" is ON.
NG: Go to step 2

OK: TURN "DAY MODE" SETTING OFF

CHECK VEHICLE SIGNAL (DISPLAY VEHICLE SIGNAL)

Enter the "Display Check" mode (Vehicle Signal Check Mode) (see DISPLAY CHECK MODE ).

Check that the display changes between DIM and BRIGHT according to the light control switch operation.

VEHICLE SIGNAL (DISPLAY VEHICLE SIGNAL)

Light Control Switch Condition	Display Condition
TAIL or ON	ON
OFF	OFF

Fig 2: Diagnostic Menu Screen Display - Vehicle Signal Check Mode

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

The display is updated once per second. It is normal for the display to lag behind the actual switch operation.

Result

LIGHT CONTROL SWITCH RESULT CHART

Result	Proceed to
OK (for Column Shift Type)	A
OK (for Floor Shift Type)	B
NG	C

B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )

C: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

A: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )