Rear Power Window Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
1. Attach the 2 claws to install the regulator switch.
  
  Fig 1: Identifying Rear Power Window Regulator Switch Assembly Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH
1. Connect the connector.
  
  Fig 2: Identifying Rear Upper Door Armrest Base Panel LH Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Attach the 2 clips and 5 claws to install the rear upper door armrest base panel.
  
  Fig 3: Identifying Rear Upper Door Armrest Base Panel Clips And Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002