Specifications Index
M35 & M45 SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | See applicable component in AUTOMATIC AIR CONDITIONER article. | ||
| Axle Nut/Hub Nut | |||
| Front Axle Nut | 125 N.m (92 Ft.lbs) | ||
| Front Hub Nuts | 88 N.m (65 Ft.lbs) | ||
| Rear Axle Nut | 175 N.m (130 Ft.lbs) | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | |||
| Front | FRONT DISC BRAKE | ||
| Rear | REAR DISC BRAKE | ||
| Torque | |||
| Front Disc Brake | COMPONENTS | ||
| Rear Disc Brakes | COMPONENTS | ||
| Charging | |||
| Generator | ALTERNATOR | ||
| Torque | REMOVAL AND INSTALLATION | ||
| Drive Belts | |||
| Adjustment | |||
| M35 | TENSION ADJUSTMENT | ||
| M45 | Belt is automatically adjusted by auto tensioner | ||
| Belt Routing | |||
| M35 | DRIVE BELT | ||
| M45 | DRIVE BELTS | ||
| Engine Cooling | |||
| General Service Specifications | |||
| M35 | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| M45 | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Radiator Cap Pressure | 78-98 kPa (0.8-1.0 kgf/cm2 , 11-14 psi) | ||
| Thermostat R & I | |||
| M35 | WATER INLET AND THERMOSTAT ASSEMBLY | ||
| M45 | THERMOSTAT AND WATER CONTROL VALVE | ||
| Water Pump R & I | |||
| M35 | WATER PUMP | ||
| M45 | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | |||
| M35 | GENERAL SPECIFICATIONS | ||
| M45 | GENERAL SPECIFICATIONS | ||
| Oil Pressure (Engine oil temperature at 80°C (176°F)) |
|||
| Idle | 98 kPa (1.0 kgf/cm2 , 14 psi) or more | ||
| 2000 RPM | 294 kPa (3.0 kgf/cm2 , 43 psi) or more | ||
| Overhaul | |||
| M35 | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| M45 | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | |||
| M35 | See applicable component in ENGINE MECHANICAL (VQ35DE) article | ||
| M45 | See applicable component in ENGINE MECHANICAL (VK45DE) article | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. Also, refer to Technical Service Bulletin INFINITI; SPECIAL AUTOMATIC TRANSMISSION FLUID REQUIREMENT . | ||
| Flywheel/Flex Plate (Drive Plate) Torque | 88.5 N.m (65 Ft.lbs) | ||
| Fuel System | |||
| Fuel Pressure | 350 kPa (3.57 kg/cm2 , 51 psi) | ||
| Fuel Pressure Test Procedure | |||
| M35 | FUEL PRESSURE CHECK | ||
| M45 | FUEL PRESSURE CHECK | ||
| Fuel Filter Location | In Tank Type | ||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| M35 | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| M45 | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil On Plug | ||
| Ignition Wires (Routing) | NA | ||
| Spark Plugs | |||
| M35 | SPARK PLUG | ||
| M45 | SPARK PLUG | ||
| Starting | |||
| Starter | |||
| M35 & M45 | STARTER | ||
| Torque | |||
| M35 & M45 | See applicable starter under REMOVAL AND INSTALLATION . | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front (2WD) | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Front (AWD) | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Rear | SERVICE DATA AND SPECIFICATIONS (SDS) | ||
| Torque | |||
| Front (2WD) | See applicable components under 2WD in FRONT SUSPENSION article. | ||
| Front (AWD) | See applicable components under AWD in FRONT SUSPENSION article. | ||
| Rear | See applicable components in REAR SUSPENSION article. | ||
| Wheel & Tire | |||
| Lug Nut Torque | 108 N.m (11 kg.m, 80 Ft.lbs) | ||
| How To Use Nissan/Infiniti Service Information | |||
| Includes: Standard Bolt Torque Symbol Identification General Connector Info |
GENERAL INFORMATION | ||