Component Inspection (RAS Motor Relay)

1. Turn the ignition switch OFF.
2. Remove RAS motor relay connector.
3. Apply 12 V to RAS motor relay connector No. 1 terminal and No. 2 terminal.
   CAUTION:

   • Never make the terminals short.
   • Connect the fuse between the terminals when applying the voltage.
4. Check the continuity between RAS motor relay connector terminals.
   CONTINUITY REFERENCE
   
   

   RAS motor relay				Continuity
   Connector	Terminal		Condition
   B36	3	5	Apply the voltage between No. 1 terminal and No. 2 terminal.	Existed
   			Do not apply the voltage between No. 1 terminal and No. 2 terminal.	Not existed

5. Check the resistance between RAS motor relay connector terminals.

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace RAS motor relay.