Component Function Check

PRECONDITIONING
WARNING: When performing the following procedure, always observe the handling of the fuel. Refer to "REMOVAL AND INSTALLATION ".

TESTING CONDITION:

Before starting component function check, preparation of draining fuel and refilling fuel is required.

GO TO 2.
PERFORM COMPONENT FUNCTION CHECK
NOTE: Start from step 8, if it is possible to confirm that the fuel cannot be drained by 30 l (7-7/8 US gal, 6-5/8 lmp gal) in advance.
1. Prepare a fuel container and a spare hose.
2. Release fuel pressure from fuel line. Refer to "INSPECTION ".
3. Remove the fuel feed hose on the fuel level sensor unit.
4. Connect a spare fuel hose where the fuel feed hose was removed.
5. Turn ignition switch ON.
6. Drain fuel by 30 l (7-7/8 US gal, 6-5/8 lmp gal) from the fuel tank using proper equipment.
7. Confirm that the fuel gauge indication varies.
8. Fill fuel into the fuel tank for 30 l (7-7/8 US gal, 6-5/8 lmp gal).
9. Confirm that the fuel gauge indication varies.
  Is the inspection result normal?
  
  YES: INSPECTION END
  
  NO: Go to "DIAGNOSIS PROCEDURE ".