DISPLAY UNIT : Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
BLOWN FUSES REFERENCE CHARTPower source Fuse No. Battery 34 Ignition switch ACC or ON 19 Is the inspection result normal?
YES: GO TO 2.
NO: Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between display unit harness connector and ground.
CONNECTOR TERMINALS VOLTAGE REFERENCE CHARTSignal name Connector No. Terminal No. Ignition switch position Value (Approx.) Battery power supply M75 2 OFF Battery voltage ACC power supply M75 3 ACC Battery voltage Is the inspection result normal?
YES: GO TO 3.
NO: Check harness between Display unit and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect display unit connector.
- Check continuity between display unit harness connector and ground.CONNECTOR TERMINALS CONTINUITY REFERENCE CHART
Signal name Connector No. Terminal No. Ignition switch position Continuity Ground M75 1 OFF Existed 13 Is the inspection result normal?
YES: INSPECTION END
NO: Repair harness or connector.