Diagnosis Procedure
- CHECK CONTINUITY RGB SYNCHRONIZING SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect display unit connector and AV control unit connector.
- Check continuity between display unit harness connector and AV control unit harness connector.CONNECTOR TERMINALS CONTINUITY REFERENCE CHART
Display unit AV control unit Continuity Connector Terminal Connector Terminal M75 19 M88 65 Existed - Check continuity between display unit harness connector and ground.CONNECTOR TERMINALS CONTINUITY REFERENCE CHART
Display unit Ground Continuity Connector Terminal M75 19 Not existed Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK RGB SYNCHRONIZING SIGNAL
- Connect display unit connector and AV control unit connector.
- Turn ignition switch ON.
- Check signal between display unit harness connector and ground.CONNECTOR TERMINALS SIGNAL CHECK REFERENCE CHART
(+) (-) Reference value Display unit Connector Terminal M75 19 Ground Is the inspection result normal?
YES: Replace display unit.
NO: Replace AV control unit.