AV CONTROL UNIT : Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
BLOWN FUSES REFERENCEPower source Fuse No. Battery 34 Ignition switch ACC or ON 19 Ignition switch ON or START 3 Is the inspection result normal?
YES: GO TO 2.
NO: Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between AV control unit harness connectors and ground.
VOLTAGE SPECIFICATIONSignal name Connector No. Terminal No. Ignition switch position Value (Approx.) Battery power supply M81 19 OFF Battery voltage M82 22 24 ACC power supply M81 7 ACC Battery voltage M82 25 Ignition signal M85 104 ON Battery voltage Is the inspection result normal?
YES: GO TO 3.
NO: Check harness between AV control unit and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect AV control unit connectors.
- Check continuity between AV control unit harness connectors and ground.CONTINUITY SPECIFICATION
Signal name Connector No. Terminal No. Ignition switch position Continuity Ground M81 8 OFF Existed 17 20 M85 85 Is the inspection result normal?
YES: INSPECTION END
NO: Repair harness or connector.