MIRROR SWITCH : Component Function Check
- CHECK MIRROR SWITCH FUNCTION
- Turn ignition switch ON.
- Select "MIR CON SW-UP/DN", "MIR CON SW-RH/LH" in the "DATA MONITOR" mode using CONSULT-III.
- Check mirror switch signal under the following conditions.MIRROR SWITCH SIGNAL CHECKING CONDITIONS
Monitor item Condition Status MIR CON SW-UP/DN When operating the mirror switch up or down side. ON Other than above. OFF MIR CON SW-RH/LH When operating the mirror switch right or left side. ON Other than above. OFF Is the inspection result normal?
YES: Mirror switch function is OK.
NO: Perform diagnosis procedure. Refer to "MIRROR SWITCH : DIAGNOSIS PROCEDURE ".