Component Inspection (ASCD Brake Switch)

1. CHECK ASCD BRAKE SWITCH-I
   1. Turn ignition switch OFF.
   2. Disconnect ASCD brake switch harness connector.
   3. Check the continuity between ASCD brake switch terminals under the following conditions.
   CONTINUITY REFERENCE
   
   

   Terminals	Condition		Continuity
   1 and 2	Brake pedal	Fully released	Existed
   		Slightly depressed	Not existed

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

2. CHECK ASCD BRAKE SWITCH-II

1. Adjust ASCD brake switch installation. Refer to "INSPECTION AND ADJUSTMENT ".
2. Check the continuity between ASCD brake switch terminals under the following conditions.

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace ASCD brake switch.