LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2009 >> G37 Base, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Security Control System -- Convertible) >> DTC/Circuit Diagnosis >> DTC B2108: Steering Lock Relay >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK STEERING LOCK RELAY

    Check voltage between IPDM E/R harness connector and ground.

    VOLTAGE SPECIFICATION

    (+) (-) Condition Voltage (V) (Approx.)
    IPDM E/R
    Connector Terminal
    E5 11 Ground Ignition switch OFF A few seconds after opening the driver door Battery voltage
    Ignition switch LOCK Press the push-button ignition switch Battery voltage
    Ignition switch ACC or ON 0

    Is the inspection normal? 

    YES: GO TO 2.

    NO: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".

  2. CHECK STEERING LOCK RELAY CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect IPDM E/R connector and steering lock unit connector.
    3. Check continuity IPDM E/R harness connector and steering lock unit harness connector.
      CONTINUITY CHART

      IPDM E/R Steering lock unit Continuity
      Connector Terminal Connector Terminal
      E5 11 M40 1 Existed
    4. Check continuity IPDM E/R harness connector and ground.
      CONTINUITY CHART

      IPDM E/R Ground Continuity
      Connector Terminal
      E5 11 Not existed

      Is the inspection result normal? 

      YES: GO TO 3.

      NO: Repair or replace harness.

  3. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    INSPECTION END

scientia non olet · About LEMON Manuals