Memory Operation
The driver seat control unit can store the optimum driving positions (seat, steering and door mirror position) for 2 people. If the front seat position is changed, one-touch (pressing desired memory switch for more than 0.5 second) operation allows changing to the other driving position.
Operation procedure
- Turn ignition switch ON.
- Press desired memory switch for 0.5 second. (Indicator LED illuminates.)
- Driver seat, steering and door mirror will move to the memorized position. (Indicator LED blinks during adjustment, then illuminates for 5 seconds.)
Operation Condition
If the following conditions are not satisfied, memory switch operation is not performed.
- Ignition switch is in ON position.
- Driver side power seat switch, ADP steering switch and door mirror control switch are not operated.
- Seat memory switch and set switch are not operated.
- Output malfunction is not detected.
- CAN and UART communications are normal.
- Selector lever position is in P position.
- Detention switch malfunction is not detected.
[Detention switch malfunction is sensed when detention switch remains OFF, vehicle speed is higher than 7 km/H. (4 MPH).]
- Input voltage from tilt sensor and telescopic sensor are normal.
NOTE:
The memory operation operates following order.
MEMORY OPERATION
| Order of priority | Operated portion | ||
|---|---|---|---|
| 1(1) | Seat sliding | ||
| 2 | Steering telescopic | ||
| 3 | Steering wheel tilt | ||
| 4 | Seat reclining | ||
| 5 | Seat lifter (front) | ||
| 6 | Seat lifter (rear) | ||
|
|||
Storing Memory Procedure
- Turn ignition switch to ON.
- Shift selector lever to P position.
- Adjust position of driver seat, steering and mirror position.
- Press set switch.
- Indicator LED for which driver seat positions are already retained in memory is illuminated for 5 seconds.
- Indicator LED for which driver seat positions are not retained in memory is illuminated for 0.5 second.
- Press memory switch for which driver seat positions are to be entered in memory for more than 0.5 second within 5 seconds after pressing the set switch (during the indicator LED is illuminated).
- To enter driver seat positions in blank memory, indicator LED will be illuminated for 5 seconds.
- To modify driver seat positions, indicator LED will be turned OFF for 0.5 second then illuminated for 5 seconds.
-
- If you need setting of INTELLIGENT KEY INTERLOCK OPERATION, continue this procedure.
- If you don't need setting of INTELLIGENT KEY INTERLOCK OPERATION, the procedure is finished. Conform the operations of each part with the MEMORY OPERATION.
- Press intelligent key unlock button within 5 seconds after pressing memory switch. (While memory switch LED is illuminated.)
- Conform the operations of each part with MEMORY OPERATION and INTELLIGENT KEY INTERLOCK OPERATION.NOTE:
- Driving position is erased from the memory when battery cable is disconnected.