Setting Change Function
WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
The settings of the automatic driving positioner system can be changed, using CONSULT-III and the display unit in the center of the instrument panel.
SETTING CHANGE FUNCTION
| x: Applicable -: Not applicable | ||||
|---|---|---|---|---|
| Setting item | Content | CONSULT-II (WORK SUPPORT) | Display unit | Factory setting |
| Change seat sliding volume setting | The distance at retain operation can be selected from the following 3 modes. | 40 mm | - | x |
| 80 mm | - | |||
| 150 mm | - | |||
| Change the Entry/Exit seat slide function setting | The seat sliding turnout and return at entry/exit can be selected: ON (operated) - OFF (not operated) | ON | ON: Indicator lamp ON | x |
| OFF | OFF: Indicator lamp OFF | - | ||
| Change the Entry/Exit tilt steering wheel function setting | Lift up and backward steering wheel at entry and exit can be selected: ON (operated) - OFF (not operated) | ON | ON: Indicator lamp ON | x |
| OFF | OFF: Indicator lamp OFF | - | ||
| Reset custom settings | All settings to default. | - | Default: Setting button OFF | - |
It is possible to set sliding driver seat for entry/exit of vehicle by pressing set switch.
SETTING CHANGE FUNCTION
| Content | Setting change operation | Indicator LED |
|---|---|---|
| The seat sliding turnout and steering wheel up/backward at entry/exit can be operated. | Press the set switch for more than 10 seconds | Blinking twice |
| The seat sliding turnout and steering wheel up/backward at entry/exit can be not operated. | Blinking ones |