Diagnostic Procedure

WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STOP LAMP SIGNAL

With CONSULT-III

Check ("STOP LAMP SW") in DATA MONITOR mode with CONSULT-III.

When depressing the break pedal

STOP LAMP SW : ON

Without CONSULT-III

Check voltage between Intelligent Key unit connector and ground.

TERMINAL VOLTAGE CHART

Terminals			Voltage (V) (Approx.)
(+)		(-)
Intelligent Key unit connector	Terminal	(-)
M32	63	Ground	Battery voltage

OK or NG

OK: XXX

NG: Check the following.

Fig 1: Checking Voltage Between Intelligent Key Unit Connector Terminal 63 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

10A fuse [No.20, located in the fuse block (J/B)]
Harness for open or short between fuse block and Intelligent Key unit.