Security Indicator Lamp Check

WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

SECURITY INDICATOR LAMP ACTIVE TEST
With CONSULT-III

Check ("THEFT IND") in "ACTIVE TEST" mode with CONSULT-III.

Perform operation shown on display indicator lamp should illuminate.

OK or NG

OK: Security indicator lamp is OK.

NG: GO TO 2.

CHECK HARNESS CONTINUITY

Turn ignition switch OFF.
Disconnect security indicator lamp connector.

Check voltage between multi-function switch (security indicator lamp) connector and ground.

TERMINAL VOLTAGE CHART

Terminals			Voltage (V) (Approx.)
(+)		(-)
Security indicator lamp connector	Terminal	(-)
M69	1	Ground	Battery voltage

Fig 1: Checking Voltage Between Multi-Function Switch (Security Indicator Lamp) Connector Terminal 1 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Check the following.

Harness for open or short between BCM and multifunction switch (security indicator lamp)
Security indicator lamp condition

NG: Check the following.

15A fuse [No.37, located in fuse block (J/B)]
Harness for open or short between multi-function switch (security indicator lamp) and fuse