DTC Check / Clear

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Refer to the Techstream operator's manual for further details.

CHECK DTC
1. Warm up the engine.
2. Turn the ignition switch OFF.
3. Connect the Techstream to the DLC3.
4. Turn the ignition switch ON.
5. Turn the tester on.
6. Enter the following menus:
  Select: Body Electrical / Main Body / Trouble Codes.
7. Read the DTCs by following the directions on the tester's screen.
CLEAR DTC
1. Warm up the engine.
2. Turn the ignition switch OFF.
3. Connect the Techstream to the DLC3.
4. Turn the ignition switch ON.
5. Turn the tester on.
6. Enter the following menus:
  Select: Body Electrical / Main Body / Trouble Codes.
7. Erase the DTCs by following the directions on the tester's screen.