Data List / Active Test
WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
- READ DATA LIST
HINT:
Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.- Warm up the engine.
- Turn the ignition switch OFF.
- Connect the Techstream to the DLC3.
- Turn the ignition switch ON.
- Turn the tester on.
- Enter the following menus:
Select: Body Electrical / Main Body / Data List.
- According to the display on tester, read the "Data List".
Main Body:
DATA LIST - MAIN BODYTester Display Measurement Item/Range Normal Condition Diagnostic Note Communication Slide Roof Connection status between sliding roof ECU and main body ECU / OK or STOP OK: Connection
STOP: No connectionWhen there is malfunction, DTC is output