Installation Of Steering Column Assembly
- Installation is the reverse order of removal. For tightening torque, Refer to "COMPONENTS ".
- After lower shaft fitted, make sure there is no gap (A) between the upper joint (1) and lower shaft.
Courtesy of NISSAN MOTOR CO., U.S.A.
- When installing upper joint, the angle which upper joint yoke (1) forms with shaft center groove (A) should be at 90°.
- Adjust neutral position of steering angle sensor. Refer to
"ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
".
Courtesy of NISSAN MOTOR CO., U.S.A.