Check Front Lifting Sensor Circuit
- CHECK FUNCTION
With CONSULT-III
Check operation with "LIFT FR PULSE" on the DATA MONITOR to make sure the pulse changes.
MONITOR ITEM REFERENCEMonitor item [OPERATION or UNIT] Contents LIFT FR PULSE - The front lifting position (pulse) judged from the lifting sensor (front) is displayed Without CONSULT-III
- Turn ignition switch OFF.
- Check signal between driver seat control unit connector and ground, with oscilloscope.TERMINAL CONDUCTION CHART
Sliding sensor front lifting sensor Terminals Condition Signal (Reference value) (+) (-) B214 25 Ground Front lifting motor operation Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
OK: Sliding sensor front lifting sensor is OK.
NG: GO TO 2.
- CHECK FRONT LIFTING MOTOR SENSOR CIRCUIT HARNESS CONTINUITY
- Disconnect driver seat control unit and sliding sensor front lifting sensor connector.
- Check continuity between driver seat control unit connector and sliding sensor front lifting sensor connector.CONTINUITY CHART
A B Continuity Driver seat control unit connector Terminal Sliding sensor front lifting sensor connector Terminal B204 25 B214 25 Yes 31 31B - Check continuity between driver seat control unit connector and ground.CONTINUITY CHART
A Ground Continuity Driver seat control unit connector Terminal B204 25 No 31 OK or NG
OK: GO TO 3.
NG: Repair or replace harness.
- CHECK DRIVER SEAT CONTROL UNIT OUTPUT
- Connect driver seat control unit connector.
- Check voltage between driver seat control unit connector and ground.VOLTAGE SPECIFICATION
Terminals Voltage (V) (Approx.) (+) (-) Driver seat control unit connector Terminal B204 25 Ground 5 OK or NG
OK: Replace sliding sensor front lifting sensor.
NG: Replace automatic drive positioner control unit.