2WD Models

WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

Loosen nut (2) of pivot pin (1).
Place PNP switch and selector lever in "P" position.
While pressing lower lever (3) toward rear of vehicle (in "P" position direction), tighten nut (2) to specified torque. Refer to "CONTROL ROD COMPONENTS (2WD MODELS) ".

Fig 1: Identifying Pivot Pin, PNP Switch And Nut (2WD Models)
Courtesy of NISSAN MOTOR CO., U.S.A.