Bleeding Brake System
WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- While bleeding, pay attention to master cylinder fluid level.
- Before working, disconnect connectors of ABS actuator and electric unit (control unit) or battery cable from the negative terminal.
- Connect a vinyl tube to rear right brake caliper bleed valve.
- Fully depress brake pedal 4 or 5 times.
- With brake pedal depressed, loosen bleed valve to bleed air in brake line, and then tighten it immediately.
- Repeat steps 2 and 3 until all of the air is out of the brake line.
- Tighten the bleed valve to the specified torque. Refer to FRONT DISC BRAKE : "COMPONENTS ", rear disc brake: "COMPONENTS ".
- From step 1 to 5, with master cylinder reservoir tank filled at least half way, bleed air from brake hydraulic line bleed valves in the following order:
Rear right brake→Front left brake→Rear left brake→Front right brake