Detailed Flow

WARNING: This page is about a different car, the 2008 Infiniti M45 and 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

INTERVIEW FOR MALFUNCTION
Interview the customer to obtain information about symptoms using DIAGNOSTIC WORK SHEET )

GO TO 2.
SELF-DIAGNOSIS WITH CONSULT-III
Perform self-diagnosis with CONSULT-III. Check if any DTC is detected.

Is any DTC detected?

Yes: GO TO 5.

No: GO TO 3.
PRE-INSPECTION FOR DIAGNOSIS
Perform pre-inspection for diagnosis. Refer to INSPECTION PROCEDURE .

GO TO 4.
VERIFY CUSTOMER CONCERN (ACTION TEST)
Perform action test and verify the customer's information. Refer to DESCRIPTION .

GO TO 6.
TROUBLE DIAGNOSIS BY DTC
Perform trouble diagnosis for the detected DTC. Specify a malfunctioning part. Refer to DTC INDEX (Lane camera unit) and/or DTC NO. INDEX [ABS actuator and electric unit (control unit)].

GO TO 7.
SYMPTOM DIAGNOSIS
Perform symptom diagnosis. Specify malfunctioning part. Refer to SYMPTOM TABLE .

GO TO 7.
MALFUNCTION PART REPAIR
Repair or replace the identified malfunctioning parts.

GO TO 8.
REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT-III)
Perform self-diagnosis with CONSULT-III. Check that any DTC is not detected. Erase DTC if DTC is detected before the repair. Check that DTC is not detected again.

Is any DTC detected?

Yes: GO TO 5.

No: GO TO 9.
REPAIR CHECK (ACTION TEST)
Perform action test. Also check the system operation.

Does it operate normally?

Yes: INSPECTION END

No: GO TO 4.