Fog Light Assembly: Installation

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.

INSTALL FOG LIGHT ASSEMBLY LH
1. for Steel Type Bumper:
  
  Fig 1: Identifying LH Fog Light Assembly Claws (Steel Type Bumper)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Attach the 2 claws to install the fog light.
  2. Attach the tabs on the fog light aiming screw to the bumper.
  3. Connect the connector.
2. for Resin Type Bumper:
  
  Fig 2: Identifying LH Fog Light Assembly Claws (Resin Type Bumper)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Attach the 2 claws to install the fog light.
  2. Attach the tabs on the fog light aiming screw to the bumper.
  3. Connect the connector.
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH