Cruise Control Main Switch: Removal

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).

NOTE: After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE LOWER NO. 2 STEERING WHEEL COVER (See REMOVAL )
REMOVE LOWER NO. 3 STEERING WHEEL COVER (See REMOVAL )
REMOVE STEERING PAD (w/o Steering Pad Switch) (See REMOVAL )
REMOVE STEERING PAD (w/ Steering Pad Switch) (See REMOVAL )
REMOVE CRUISE CONTROL MAIN SWITCH
1. Disconnect the connector.
2. Remove the 2 screws.
  
  Fig 1: Locating Cruise Control Main Switch Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the switch, as shown in the illustration.
  
  Fig 2: Identifying Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002