Adjustment of A/T Position

WARNING: This page is about a different car, the 2008 Infiniti FX45 and 2008 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Loosen nut of control rod.
Place PNP switch and selector lever in "P" position.
While pressing lower lever toward rear of vehicle (in "P" position direction), tighten nut to the specified torque. Refer to "CONTROL ROD COMPONENTS ".

CAUTION: Do not push the bracket.

Fig 1: Identifying Lower Lever Control Rod And Bracket Nut

Courtesy of NISSAN MOTOR CO., U.S.A.