Removal and Installation: Installation
Install in the reverse order of removal.
CAUTION:
- Never use the old TORX bolts after removal, replace with the new bolts.
- Fix the air bag module harness (shown as A in the figure) to the harness fixing hook (shown as B in the figure).
- Never damage the harness while installing.
- Tighten the TORX bolts after completely adjusting the centers of fixing holes on the driver air bag module side and the steering wheel side. If the holes are misaligned, the bolt threads are damaged and the module is not installed securely.
- If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunctioning parts, reset the memory using self-diagnosis or CONSULT-III. Refer to "SRS OPERATION CHECK (USER MODE) ".
- After the work is completed, check that no system malfunction is detected by air bag warning lamp.