Diagnosis Procedure
- CHECK LOAD SIGNAL CIRCUIT OVERALL FUNCTION-I
- Turn ignition switch ON.
- Connect CONSULT-III and select "DATA MONITOR" mode.
- Select "LOAD SIGNAL" and check indication under the following conditions.LOAD SIGNAL INDICATION CONDITION
Condition Indication Rear window defogger switch: ON ON Rear window defogger switch: OFF OFF OK or NG
OK: GO TO 2.
NG: GO TO 4.
- CHECK LOAD SIGNAL CIRCUIT OVERALL FUNCTION-II
Check "LOAD SIGNAL" indication under the following conditions.
LOAD SIGNAL INDICATION CONDITIONCondition Indication Heater fan control switch: ON ON Heater fan control switch: OFF OFF OK or NG
OK: GO TO 3.
NG: GO TO 5.
- CHECK HEATER FAN SIGNAL CIRCUIT OVERALL FUNCTION
Select "HEATER FAN SW" and check indication under the following conditions.
HEATER FAN SIGNAL INDICATION CONDITIONCondition Indication Lighting switch: ON at 2nd position ON Lighting switch: OFF OFF OK or NG
OK: INSPECTION END
NG: GO TO 6.
- CHECK REAR WINDOW DEFOGGER SYSTEM
Refer to REAR WINDOW DEFOGGER SYSTEM .
INSPECTION END
- CHECK HEADLAMP SYSTEM
Refer to HEADLAMP , or DAYTIME LIGHT SYSTEM .
INSPECTION END
- CHECK HEATER FAN CONTROL SYSTEM
Refer to BLOWER MOTOR CONTROL SYSTEM .
INSPECTION END