Inspection After Assembly

When the steering wheel does not turn smoothly, check the steering column as follows:

1. Check the column bearings for damage or unevenness. Lubricate with recommended multi-purpose grease. Replace the steering column as an assembly, if necessary.
2. Check the column tube for deformation or breakage. Replace the steering column as an assembly, if necessary.
3. If the vehicle has been involved in a collision, or if noise and rattles are heard during a turn, check the length "L" of the column.
   Fig 1: Identifying Steering Column Length (L)

   Courtesy of NISSAN MOTOR CO., U.S.A.

   If out of specification, replace the steering column as an assembly.

   Steering column length "L" 

   L: 610 mm (24.02 in) 

   L ¹  : 158 mm (6.22 in) 

   L ²  : 262 mm (10.31) 

   Fig 2: Identifying Steering Column Length (L1, L2)

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Check for proper lubrication, apply grease as necessary.
5. Check for wear around the seal edges, replace the steering column as an assembly as necessary.
6. Check for corrosion or pitting around the seal sliding area.
7. Replace the seal and shaft in case of seal edge wear or damage.
8. After installing the steering column, check the tilt mechanism for proper operation.

   Range "A": 61.3 mm (2.41 in) 

   : 3° per notch at 5 steps 

   Fig 3: Identifying Tilt Device Operation Range

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 4: [Identifying Tilt Mechanism Operation Range]

   Courtesy of NISSAN MOTOR CO., U.S.A.
   CAUTION:

   • Do not exert any load in the axial direction immediately before or after column removal.
   • After installation, check smooth steering wheel rotation, without any catches or noise.