LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> EX35 Base, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio, Visual, Navigation System >> Base Audio Without Navigation >> Component Diagnosis >> Rear View Camera Image Signal Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT
    1. Turn ignition switch OFF.
    2. Disconnect camera control unit connector and rear view camera connector.
    3. Check continuity between camera control unit harness connector and rear view camera harness connector.
      CONTINUITY REFERENCE CHART

      Camera control unit Rear view camera Continuity
      Connector Terminal Connector Terminal
      B50 6 D121 3 Existed
    4. Check continuity between camera control unit harness connector and ground.
      CONTINUITY REFERENCE CHART

      Camera control unit Ground Continuity
      Connector Terminal
      B50 6 Not existed

      Is inspection result normal? 

      YES: GO TO 2.

      NO: Repair harness or connector.

  2. CHECK CAMERA IMAGE SIGNAL
    1. Connect camera control unit connector and rear view camera connector.
    2. Turn ignition switch ON.
    3. Check signal between camera control unit harness connector and ground.
      SIGNAL REFERENCE CHART

      (+) (-) Condition Reference value
      Camera control unit
      Connector Terminal
      B50 6 Ground At rear view camera image is displayed.
      G04890020Courtesy of NISSAN MOTOR CO., U.S.A.

      Is inspection result normal? 

      YES: Replace camera control unit.

      NO: Replace rear view camera.

scientia non olet · About LEMON Manuals