WITH REAR VIEW MONITOR : Diagnosis Procedure
- CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect camera control unit connector and display unit connector.
- Check continuity between camera control unit harness connector and display unit harness connector.CONTINUITY REFERENCE CHART
Camera control unit Display unit Continuity Connector Terminal Connector Terminal B50 12 M75 12 Existed - Check continuity between camera control unit harness connector and ground.CONTINUITY REFERENCE CHART
Camera control unit Ground Continuity Connector Terminal B50 12 Not existed Is inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK CAMERA IMAGE SIGNAL
- Connect camera control unit connector and display unit connector.
- Turn ignition switch ON.
- Shift position is "R".
- Check signal between camera control unit harness connector and ground.SIGNAL REFERENCE CHART
(+) (-) Condition Reference value Camera control unit Connector Terminal B50 12 Ground At rear view camera image display Is inspection result normal?
YES: Replace display unit.
NO: Replace camera control unit.