Diagnosis Procedure
- CHECK CONTINUITY STEERING ANGLE SENSOR SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect camera control unit connector and steering angle sensor connector.
- Check continuity between camera control unit harness connector and steering angle sensor harness connector.CONTINUITY REFERENCE CHART
Camera control unit Steering angle sensor Continuity Connector Terminals Connector Terminals B50 23 M37 3 Existed 24 4 25 5 - Check continuity between camera control unit harness connector and ground.CONTINUITY REFERENCE CHART
Camera control unit Ground Continuity Connector Terminals B50 23 Not existed 24 25 Is inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK VOLTAGE CAMERA CONTROL UNIT
- Connect camera control unit connector.
- Turn ignition switch ON.
- Check voltage between camera control unit harness connector and ground.VOLTAGE REFERENCE CHART
(+) (-) Voltage (Approx.) Camera control unit Connector Terminals B50 23 Ground 5.0 V 24 25 Is inspection result normal?
YES: GO TO 3.
NO: Replace camera control unit.
- CHECK STEERING ANGLE SENSOR SIGNAL
- Turn ignition switch OFF.
- Connect steering angle sensor connector.
- Turn ignition switch ON.
- Check signal between camera control unit harness connector and ground.SIGNAL REFERENCE CHART
(+) (-) Condition Reference value Camera control unit Connector Terminals B50 23, 24 Ground Turn the steering to the right Turn the steering to the left 25 Ground Turn the steering around the neutral position Is inspection result normal?
YES: INSPECTION END
NO: Replace steering angle sensor.