Detail Flow
Seat
CONTROL UNIT CONDITION CHART
| Order | Input | Output | Control unit condition |
|---|---|---|---|
| 1 | Power seat switch (sliding, lifting, reclining) | - | The power seat switch signal is inputted to the driver seat control unit when the power seat switch is operated. |
| 2 | - | Motors (sliding, lifting, reclining) | The driver seat control unit outputs signals to each motor according to the power seat switch input signal. |
Tilt & Telescopic
CONTROL UNIT CONDITION CHART
| Order | Input | Output | Control unit condition | ||
|---|---|---|---|---|---|
| 1 | Tilt & telescopic switch | - | The tilt & telescopic switch signal is inputted to the automatic drive positioner control unit when the tilt & telescopic switch is operated. | ||
| 2 | - | Motors (Tilt, telescopic) | The automatic drive positioner control unit actuates each motor according to the operation of the tilt & telescopic switch. | ||
| 3 | Sensors (Tilt, telescopic) | - | The automatic drive positioner control unit recognizes any operation limit of each actuator via each sensor and will not operate the actuator anymore at that time.(1) | ||
|
|||||
Door Mirror
CONTROL UNIT CONDITION CHART
| Order | Input | Output | Control unit condition |
|---|---|---|---|
| 1 | Door mirror remote control switch | - | The door mirror remote control switch signal is inputted to the automatic drive positioner control unit when the door mirror remote control switch is operated. |
| 2 | - | Motors (Door mirror motor) | The automatic drive positioner control unit actuates each motor according to the operation of the door mirror remote control switch. |
NOTE:
The door mirrors can be operated manually when ignition switch is in either ACC or ON position. The ignition switch signal (ACC/ON) is transmitted from BCM to the driver seat control unit via CAN communication and from the driver seat control unit to the automatic drive positioner control unit via UART communication.