Data Monitor
Display Item List
DISPLAY ITEM LIST
| x: Applicable : ↓ Optional item | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| Monitor item (Unit) | SELECT MONITOR ITEM | Remarks | |||||||
| ECU INPUT SIGNALS | MAIN SIGNALS | ||||||||
| FR LH SENSOR [km/h (MPH)] | x | x | Wheel speed | ||||||
| FR RH SENSOR [km/h (MPH)] | x | x | |||||||
| RR LH SENSOR [km/h (MPH)] | x | x | |||||||
| RR RH SENSOR [km/h (MPH)] | x | x | |||||||
| STOP LAMP SW (On/Off) | x | x | Stop lamp switch signal status | ||||||
| BATTERY VOLT (V) | x | x | Battery voltage supplied to the ABS actuator and electric unit (control unit) | ||||||
| GEAR | x | x | Gear position determined by TCM | ||||||
| SLCT LVR POSI | x | x | A/T selector lever position | ||||||
| YAW RATE SEN (d/s) | x | x | Yaw rate detected by yaw rate/side G sensor | ||||||
| ACCEL POS SIG (%) | x | ↓ | Throttle actuator opening/closing is displayed (Linked with accelerator pedal) | ||||||
| SIDE G-SENSOR (m/s2 ) | x | ↓ ↓ |
Transverse G detected by yaw rate/side G sensor | ||||||
| STR ANGLE SIG (°) | x | ↓ | Steering angle detected by steering angle sensor | ||||||
| PRESS SENSOR (bar) | x | ↓ | Brake fluid pressure detected by pressure sensor | ||||||
| ENGINE RPM [tr/min (rpm)] | x | ↓ | Engine speed | ||||||
| FLUID LEV SW (On/Off) | x | ↓ | Brake fluid level switch signal status | ||||||
| PARK BRAKE SW (On/Off) | x | ↓ | Parking brake switch signal status | ||||||
| LDP) APP SEN (%) ((2)) | x | x | Accelerator pedal position sensor status received from ECM via CAN communication | ||||||
| FR RH IN SOL (On/Off) ((1)) | ↓ | x | Operation status of each solenoid valve | ||||||
| FR RH OUT SOL (On/Off) ((1)) | ↓ | x | |||||||
| FR LH IN SOL (On/Off) ((1)) | ↓ | x | |||||||
| FR LH OUT SOL (On/Off) ((1)) | ↓ | x | |||||||
| RR RH IN SOL (On/Off) ((1)) | ↓ | x | |||||||
| RR RH OUT SOL (On/Off) ((1)) | ↓ | x | |||||||
| RR LH IN SOL (On/Off) ((1)) | ↓ | x | |||||||
| RR LH OUT SOL (On/Off) ((1)) | ↓ | x | |||||||
| MOTOR RELAY (On/Off) | ↓ | x | Motor and motor relay operation | ||||||
| ACTUATOR RLY (On/Off) ((1)) | ↓ | x | Actuator relay operation | ||||||
| ABS WARN LAMP (On/Off) | ↓ | x | ABS warning lamp | ||||||
| OFF LAMP (On/Off) | ↓ | x | VDC OFF indicator lamp | ||||||
| SLIP LAMP (On/Off) | ↓ | x | SLIP indicator lamp | ||||||
| EBD SIGNAL (On/Off) | ↓ | ↓ | EBD operation | ||||||
| ABS SIGNAL (On/Off) | ↓ | ↓ | ABS operation | ||||||
| TCS SIGNAL (On/Off) | ↓ | ↓ | TCS operation | ||||||
| VDC SIGNAL (On/Off) | ↓ | ↓ | VDC operation | ||||||
| EBD FAIL SIG (On/Off) | ↓ | ↓ | EBD fail-safe signal | ||||||
| ABS FAIL SIG (On/Off) | ↓ | ↓ | ABS fail-safe signal | ||||||
| TCS FAIL SIG (On/Off) | ↓ | ↓ | TCS fail-safe signal | ||||||
| VDC FAIL SIG (On/Off) | ↓ | ↓ | VDC fail-safe signal | ||||||
| CRANKING SIG (On/Off) | ↓ | ↓ | Crank operation | ||||||
| USV[FR-RL] (On/Off) ((1)) | ↓ | ↓ | VDC switch-over valve | ||||||
| USV[FL-RR] (On/Off) ((1)) | ↓ | ↓ | |||||||
| HSV[FR-RL] (On/Off) ((1)) | ↓ | ↓ | |||||||
| HSV[FL-RR] (On/Off) ((1)) | ↓ | ↓ | |||||||
| V/R OUTPUT (On/Off) | ↓ | ↓ | Solenoid valve relay activated | ||||||
| ↓ M/R OUTPUT (On/Off) |
↓ | ↓ | Actuator motor and motor relay activated | ||||||
| LDP) APP SEN (%) ((2)) | x | x | Accelerator pedal position sensor status received from ECM via CAN communication | ||||||
| LDP) ICC MAIN SW (On/Off) ((2)) | x | x | ICC main switch status received from ECM via CAN communication | ||||||
| LDP) LDP ON SW (On/Off) ((2)) | x | x | LDP ON switch status received from ECM via CAN communication | ||||||
| LDP) WIPER SIGNAL (Stop/PRTCT/1low/1high/Low/High) ((2)) | x | x | Front wiper operating condition received from BCM via | ||||||
| CAN communication LDP) BRAKE SW (On/Off) ((2)) | x | x | Brake switch signal status | ||||||
| LDP) STOP LMP SW (On/Off) ((2)) | x | x | Stop lamp switch signal status | ||||||
| LDP) LDW SW (On/Off) ((2)) | x | x | LDW switch status received from lane camera unit via CAN communication | ||||||
| LDP) SHIFT POSITION (OFF/P/R/N/D/MM 1st - MM 5th) ((2)) | x | x | Shift position received from TCM via CAN communication | ||||||
| LDP) TURN SIGNAL (Off/LH/RH/LH&RH) ((2)) | x | x | Turn signal operating condition received from BCM via CAN communication | ||||||
| LDP) YAW ORDER (x100Nm) ((2)) ((3)) | - | - | Calculated target yaw moment | ||||||
| LDP) WARN REQ (On/Off) ((2)) ((3)) | - | - | Status of warning request that transmits to lane camera unit via CAN communication | ||||||
| LDP) WARN CONTROL (On/Off) ((2)) ((3)) | - | - | Status of warning main controller for LDP | ||||||
| LDP) REDY SIGNAL (On/Off) ((2)) ((3)) | - | - | Status of internal judgment by LDP controller [ABS actuator and electric unit (control unit)] | ||||||
| LDP) STATUS SIGNAL (STANDBY/WARN/MASK/Off) ((2)) ((3)) | - | - | Status of internal judgment by LDP controller [ABS actuator and electric unit (control unit)] | ||||||
| LDP) CAMERA LOST (Detect/Deviate/Both) ((2)) ((3)) | - | - | Lane marker detected condition received from lane camera unit via CAN communication | ||||||
| LDP) LANE UNCLEAR (On/Off) ((2)) ((3)) | - | - | Lane marker condition received from lane camera unit via CAN communication | ||||||
|
|||||||||