Diagnosis Procedure
- CHECK CONTINUITY VERTICAL SYNCHRONIZING (VP) SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect rear display unit connector and video distributor connector.
- Check continuity between rear display unit harness connector and video distributor harness connector.TERMINAL CONTINUITY REFERENCE TABLE
Rear display unit Video distributor Continuity Connector Terminal Connector Terminal B26 17 M97 29 Existed - Check continuity between rear display unit harness connector and ground.TERMINAL CONTINUITY REFERENCE TABLE
Rear display unit Ground Continuity Connector Terminal B26 17 Not existed Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK VERTICAL SYNCHRONIZING (VP) SIGNAL
- Connect rear display unit connector and video distributor connector.
- Turn ignition switch ON.
- Check signal between rear display unit harness connector and ground using an oscilloscope.TERMINAL CONNECTOR REFERENCE TABLE
(+) (-) Condition Reference value Rear display unit Connector Terminal B26 17 Ground - Is the inspection result normal?
YES: Replace video distributor.
NO: Replace rear display unit.