LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> FX35 AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio, Visual, Navigation System (With Navigation - Twin Monitor) >> Component Diagnosis >> RGB Area (YS) Signal Circuit (Av Control Unit To Front Display Unit) >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK CONTINUITY RGB AREA (YS) SIGNAL CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect front display unit connector and AV control unit connector.
    3. Check continuity between front display unit harness connector and AV control unit harness connector.
      TERMINAL CONTINUITY REFERENCE TABLE

      Front display unit AV control unit Continuity
      Connector Terminal Connector Terminal
      M75 9 M88 67 Existed
    4. Check continuity between front display unit harness connector and ground.
      TERMINAL CONTINUITY REFERENCE TABLE

      Front display unit Ground Continuity
      Connector Terminal
      M75 9 Not existed

      Is inspection result normal? 

      YES: GO TO  2.

      NO: Repair harness or connector.

  2. CHECK RGB SYNCHRONIZING SIGNAL 
    1. Connect front display unit connector and AV control unit connector.
    2. Turn ignition switch ON.
    3. Check signal between front display unit harness connector and ground.
      TERMINAL CONNECTOR REFERENCE TABLE

      (+) (-) Condition Reference value (Approx.)
      Front display unit
      Connector Terminal
      M75 9 Ground At RGB image displayed 5.0 V
      At AUX image displayed
      G05219862Courtesy of NISSAN MOTOR CO., U.S.A.

      Is inspection result normal? 

      YES: Replace front display unit.

      NO: Replace AV control unit.

scientia non olet · About LEMON Manuals