LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> FX35 AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio, Visual, Navigation System (Without Navigation) >> Component Diagnosis >> Camera Image Signal Circuit (Camera Control Unit To Av Control Unit) >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT (CAMERA CONTROL UNIT TO AV CONTROL UNIT) 
    1. Turn ignition switch OFF.
    2. Disconnect camera control unit connector and AV control unit connector.
    3. Check continuity between camera control unit harness connector and AV control unit harness connector.
      CONTINUITY TABLE

      Camera control unit AV control unit Continuity
      Connector Terminal Connector Terminal
      B50 12 M84 65 Existed
    4. Check continuity between camera control unit harness connector and ground.
      CONTINUITY TABLE

      Camera control unit Ground Continuity
      Connector Terminal
      B50 12 Not existed

      Is inspection result normal? 

      YES: GO TO  2.

      NO: Repair harness or connector.

  2. CHECK CAMERA IMAGE SIGNAL (CAMERA CONTROL UNIT TO AV CONTROL UNIT) 
    1. Connect camera control unit connector and AV control unit connector.
    2. Turn ignition switch ON.
    3. Check signal between camera control unit harness connector and ground.
      CONNECTOR TERMINAL REFERENCE VALUE TABLE

      (+) (-) Condition Reference value
      Camera control unit
      Connector Terminal
      B50 12 Ground At rear view camera image is displayed.
      G05976558Courtesy of NISSAN MOTOR CO., U.S.A.

      Is inspection result normal? 

      YES: Replace AV control unit.

      NO: Replace camera control unit.

scientia non olet · About LEMON Manuals