LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Security Control System (Without Intelligent Key System)) >> Component Diagnosis >> Glass Hatch Ajar Switch >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

WARNING: This page is about a different car, the 2010 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM - VEHICLE SECURITY SYSTEM ".

  1. CHECK GLASS HATCH AJAR SWITCH INPUT SIGNAL

    With CONSULT-III

    Check glass hatch ajar switch "GLASS HATCH SW" in DATA MONITOR mode with CONSULT-III.

    • When glass hatch is open:

      GLASS HATCH SW :ON 

    • When glass hatch is closed:

      GLASS HATCH SW :OFF 

    Without CONSULT-III

    1. Turn ignition switch OFF.
    2. Check voltage between BCM connector M19 terminals 42 and ground.
      VOLTAGE SPECIFICATION

      Connector Item Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      M19 BCM 42 Ground Open

      Closed
      0

      Battery voltage

      Is the inspection result normal? 

      YES: Glass hatch ajar switch circuit is OK.

      NO: GO TO  2

      Fig 1: Checking Voltage Between BCM Connector M19 Terminals 42 And Ground
      G05941371Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK GLASS HATCH AJAR SWITCH CIRCUIT
    1. Disconnect glass hatch ajar switch and BCM.
    2. Check continuity between BCM connector M19 (A) terminal 42 and glass hatch ajar switch connector D503 (B) terminal 1.

      42 - 1 :Continuity should exist 

    3. Check continuity between BCM connector M19 (A) terminal 42 and ground.

      42 - Ground :Continuity should not exist 

      Is the inspection result normal? 

      YES: GO TO  3

      NO: Repair or replace harness.

      Fig 2: Checking Continuity Between BCM Connector M19 Terminal 42 And Ground
      G05941372Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK GLASS HATCH AJAR SWITCH

    Check continuity between glass hatch ajar switch connector terminal 1 and ground.

    CONTINUITY SPECIFICATION

      Terminals Condition Continuity
    Glass hatch ajar switch 1 - Ground Open Yes
    Closed No

    Is the inspection result normal? 

    YES: Refer to "INTERMITTENT INCIDENT ".

    NO: Replace glass hatch ajar switch.

    Fig 3: Checking Continuity Between Glass Hatch Ajar Switch Connector Terminal 1 And Ground
    G05381892Courtesy of NISSAN MOTOR CO., U.S.A.