LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2010 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 179 (Brake Control System) >> Function Diagnosis >> Diagnosis System [Abs Actuator And Electric Unit (Control Unit)] >> CONSULT-III Function (ABS) >> Self Diagnostic Result Mode >> How to Erase Self-diagnostic Result
April 5, 2026: LEMON Manuals is launched! Read the announcement.

How to Erase Self-diagnostic Result

WARNING: This page is about a different car, the 2011 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. After erasing DTC memory, start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute as the final inspection, and make sure that the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp turn OFF.
    CAUTION: If memory cannot be erased, perform applicable diagnosis.
    NOTE:
    • When the wheel sensor malfunctions, after inspecting the wheel sensor system, the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp will not turn OFF even when the system is normal unless the vehicle is driving at approximately 30 km/h (19 MPH) or more for approximately 1 minute.
    • Brake warning lamp will turn ON in case of parking brake operation (when switch is ON) or of brake fluid level switch operation (when brake fluid is insufficient).
    • VDC OFF switch should not stay "ON" position.
scientia non olet · About LEMON Manuals