Initialization Procedure
WARNING: This page is about a different car, the 2011 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If control unit has been replaced, proceed to step 3.
- CLEAR INITIALIZATION FLAG AND VALUE
- Using CONSULT-III select "CLEAR HEIGHT INI" in "WORK SUPPORT".
- Select "Start" to clear initialization flag and value.
- CK SUSP warning lamp in combination meter should illuminate.
GO TO 2
- RELEASE AIR PRESSURE FROM REAR LOAD LEVELING SUSPENSION
- Select "EXHAUST SOLENOID" in "ACTIVE TEST".
- Select "On" to release the air pressure from the rear load leveling air suspension system.
GO TO 3
- MOVE VEHICLE
Roll vehicle forward and backward.
GO TO 4
- SET INITIALIZATION CONDITION
- Select "ADJUST HEIGHT INI" in "WORK SUPPORT".
- Select "Start" to set initialization condition.
- Confirm that CK SUSP warning lamp in combination meter is OFF.
Initialization complete.