Component Inspection

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

CHECK BRAKE PEDAL POSITION SWITCH

Turn ignition switch OFF.
Disconnect brake pedal position switch harness connector.

Check continuity between brake pedal position switch harness connector terminals.

BRAKE PEDAL POSITION SWITCH CONTINUITY CHART

Brake pedal position switch	Condition	Continuity
Terminal	Condition	Continuity
1 - 2	Brake pedal is fully released.	Not existed
1 - 2	Brake pedal is slightly depressed.	Existed

Is the inspection result normal?

YES: INSPECTION END

NO: Replace brake pedal position switch. Refer to "REMOVAL AND INSTALLATION ".