Configuration (BCM): Description

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle specification needs to be written with CONSULT-III because it is not written after replacing BCM.

Configuration has three functions as follows.

CONFIGURATION FUNCTION CHART

Function	Description
READ CONFIGURATION	Reads the vehicle configuration of current BCM. Saves the read vehicle configuration.
WRITE CONFIGURATION - Manual selection	Writes the vehicle configuration with manual selection.
WRITE CONFIGURATION - Config file	Writes the vehicle configuration with saved data.

NOTE: Manual setting item: Items which need selection by vehicle specifications
Automatic setting item: Items which are written in automatically (Setting can not be changed)

CAUTION:

When replacing BCM, you must perform "WRITE CONFIGURATION" with CONSULT-III.
Complete the procedure of "WRITE CONFIGURATION" in order.
If you set incorrect "WRITE CONFIGURATION", incidents might occur.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
Never perform "WRITE CONFIGURATION" when performing operations other than the below.
- Replacing with new BCM
- Changing "SECURITY ALARM SET(SIREN)" of work support from ON to OFF*

NOTE: *: Perform configuration in "WRITE CONFIGURATION - Manual selection" after performing this work support.