Work Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

WRITING MODE SELECTION
CONSULT-III Configuration

Select "CONFIGURATION" of BCM.

When writing saved data: GO TO 2.

When writing manually: GO TO 3.
PERFORM "WRITE CONFIGURATION - CONFIG FILE"
CONSULT-III Configuration

Perform "WRITE CONFIGURATION - Config file".

WORK END
PERFORM "WRITE CONFIGURATION - MANUAL SELECTION"
CONSULT-III Configuration
1. Select "WRITE CONFIGURATION - Manual selection".
2. Identify the correct model and configuration list. Refer to , "CONFIGURATION LIST ".
3. Confirm and/or change setting value for each item.
  CAUTION: Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.
4. Select "SETTING".
  CAUTION: Make sure to select "SETTING" even if the indicated configuration of brand new BCM is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model can not be memorized.
5. When "COMMAND FINISHED", select "END".
  GO TO 4.
OPERATION CHECK
Confirm that each function controlled by BCM operates normally.

WORK END