Diagnosis Procedure
WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK STEERING SWITCH SIGNAL GROUND CIRCUIT
- Disconnect NAVI control unit connector and spiral cable connector.
- Check continuity between NAVI control unit harness connector and spiral cable harness connector.
CONTINUITY REFERENCE CHARTNAVI control unit Spiral cable Continuity Connector Terminal Connector Terminal M107 15 M33 33 Existed Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK SPIRAL CABLE
Check spiral cable.
Is the inspection result normal?
YES: GO TO 3.
NO: Replace spiral cable. Refer to "EXPLODED VIEW ".
- CHECK GROUND CIRCUIT
- Connect NAVI control unit connector.
- Check continuity between NAVI control unit harness connector and ground.
CONTINUITY REFERENCE CHARTNAVI control unit Ground Continuity Connector Terminal M107 15 Existed Is the inspection result normal?
YES: GO TO 4.
NO: Replace NAVI control unit. Refer to "REMOVAL AND INSTALLATION ".
- CHECK STEERING SWITCH
- Turn ignition switch OFF.
- Check steering switch. Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: INSPECTION END
NO: Replace steering switch. Refer to "EXPLODED VIEW ".