Operation Flow

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Theft Warning Alarm Operation Flow Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

THEFT WARNING ALARM SWITCHING CONDITION CHART

No.	System state	Switching condition
1	DISARMED to PRE-ARMED	When all conditions of A and one condition of B is satisfied.	A	B
1	DISARMED to PRE-ARMED		Power supply position: OFF All doors: Closed	All doors are locked by: Door key cylinder LOCK switch LOCK button of Intelligent Key Door request switch Door lock and unlock switch
2	PRE-ARMED to ARMED	When all of the following conditions are satisfied for 30 seconds.	Power supply position: OFF All doors: Locked
3	ARMED to ALARM	When all conditions of A and of B are satisfied.	A	B
3	ARMED to ALARM	When all conditions of A and of B are satisfied.	Intelligent Key: Not used	Any door: Open
4	DISARMED to PRE-RESET	No conditions.	-
5	PRE-ARMED to PRE-RESET
6	ARMED to PRE-RESET
7	ALARM to PRE-RESET
8	PRE-RESET to DISARMED
9	PRE-RESET to PRE-ARMED
10	PRE-ARMED to DISARMED	When one of the following condition is satisfied.	Power supply position: ACC/ON/CRANKING/RUN Door key cylinder UNLOCK switch: ON UNLOCK button of Intelligent Key: ON Door request switch: ON Back door opener switch: ON Any door: Open
11	ARMED to DISARMED	When one of the following condition is satisfied.	Power supply position: ACC/ON/CRANKING/RUN Door key cylinder UNLOCK switch: ON UNLOCK button of Intelligent Key: ON Door request switch: ON Back door opener switch: ON
12	ALARM to DISARMED	When one of the following condition is satisfied.
13	RE-ALARM	When the following condition is satisfied after the ALARM operation is finished.	Any door: Open

NOTE:

BCM ignores the door key cylinder UNLOCK switch signal input for 1 second after the door key cylinder LOCK switch signal input.
To lock/unlock all doors by operating remote controller button of Intelligent Key or door request switch, Intelligent Key must be within the detection area of outside key antenna. For details, refer to "DOOR LOCK FUNCTION : SYSTEM DESCRIPTION ".
To open back door by operating back door opener switch, Intelligent Key must be within the detection area of outside key antenna. For details, refer to "DOOR LOCK FUNCTION : SYSTEM DESCRIPTION ".